All Available Colours

On-screen colours may vary according to different screen calibrations so we always recommend purchasing a sample pot first if colour is critical and always applying a test area before painting.
Need help?

01604 621150

from 8:30am-5:00pm

Bona Traffic HD 5lt Matt

Bona Traffic HD 5lt Matt
Excl. VAT: £87.33 Incl. VAT: £104.80

Availability: In stock


product information


• An ideal choice for shops and public locations where minimal downtime is important

• For use when the highest possible durability is required.

• Its low emissions and low odour make it possible to use without vacating the adjacent areas

• It also ensures there is no lingering smell.

• Recommended for overcoating prefinished parquet.

technical specifications


Brand Bona
No of coats 2
Coverage Up to 10 per litre
Drying Times 8 hours
Size 5lt
MPN 7312799215569
GTIN WT155646001


• Allows full traffic after 12 hours, extremely rapid hardness development
• Ultimate durability
• EC1RPLUS approved. The industry's best possible assurance against indoor air pollution for a high level of health protection 
• Suitable for recoating already finished surfaces*
• Very low odour
• Non-yellowing
• Friction approved to both EN 14904:2006 and DIN 18032:2



Before Using Bona HD Traffic

Prior to application the surface must be pre-treated with a waterborne primer from Bona. Ensure floor is acclimatized to its end-use environment, well sanded, dry and free from sanding dust, oil, wax and other contamination.

Allow lacquer and hardener to reach room temperature.

Optimal application conditions are between 18-25C and 30-60% relative air humidity. High temperatures and low humidity shorten, low temperatures and high humidity lengthen drying time. Minimum temperature for use is 13C.

Preparation of previously lacquered floors Bona Traffic HD Anti-slip has in general very good adhesion to factory pre-finished and previously lacquered floors but the surface must be carefully cleaned and abraded prior to overcoating.

See separate guideline for overcoating recommendations.



How To Apply Bona HD Traffic


Shake the Traffic HD can and add one bottle of Traffic HD Hardener. Immediately shake the mixture thoroughly for 1 minute and then insert the enclosed filter. If mixing smaller quantities of lacquer then pour the required amount of lacquer into a separate can. 1 litre of lacquer corresponds to one part of hardener. 2 litres to two parts a.s.o. The mixture of lacquer/hardener should be used directly or at least within 4 hours.


Apply the lacquer using a Bona Roller. Roll with a smooth, flowing motion alternately across and with the grain of the wood avoiding accumulations of product. Always maintain a “wet edge” to avoid overlaps. Allow to dry properly before applying further layers. Anticipate slightly longer drying time for each layer that is applied.


If necessary make an intermediate sanding using a screen or the Bona Scrad System grit P150 (or finer) and remove dust before applying a final layer of lacquer. Note: If the previous layer of lacquer has been allowed more than 24 hours drying time then an intermediate sanding is always required.

Floor will take light foot traffic approximately 8 hours after the final application and may be put into full use after 12 hours. Allow the surface to dry for at least 3 days before covering with carpets or other floor coverings. Also avoid placing heavy objects and avoid damp mopping the floor during this time.

Note: If Traffic HD has been combined with Bona Prime Deep and Bona Create then the surface must be allowed to cure for 1 week before covering the surface



Customer reviews